Dick's Workshop
What's New
The Work
The Shop
The Maker
The Pineapple Chopper

This knife was a bit of an experiment; a creative little departure between orders and a bit of an experiment in several regards. It was the first time I’d forged a blade out of 90MnCrV8, a deep-hardening tool steel similar to O2 but without nickel. It was also the first time I’d used Katalox as a handle material, and the first time I’d done a textured and etched carbon steel plate guard like this. I definitely learned a few things during the process of making this knife, but in the end I also enjoyed the results. It’s a lot of fun to cut with!

pchop

The blade is fairly slim at just under 5mm at the ricasso, which makes it a light, quick, and smooth cutter, but at over 25cm (10 inches) from tip to guard, it also boasts also fairly good reach. It’s great for clearing brush or slashing your way through thick vegetation in your favorite forest.

pchop3

As mentioned previously, the guard is textured and etched carbon steel, set off by stainless and carbon steel spacers. The spine and ricasso of the blade also retain a rough as-forged finish, providing a nice contrast against the 600-grit satin finished blade.

pchop2

The katalox handle shows rich, dark tones and a lovely, subtle figure in the grain. With a slight drop at the heel it indexes nicely in the hand and offers a sure and comfortable grip while cutting and chopping.

Overall length is just under 40cm, or about 15 1/2 inches. Currently available.

Link